Multi-Tech Systems MVP200 quick start Configure Client MultiVOIPs

Page 33

Configure Client MultiVOIPs

7.Repeat the above steps to configure the interface type for each voice/fax channel.

The Voice/Fax tab displays the parameters for the voice coder, faxing, and DTMF gain.

8.To change the voice coder, select the channel from the Select Channel list, then select the new voice coder entry from the Voice Coder list.

If you changed the voice coder, ensure that the same voice coder is used on the voice/fax channel you are calling. Otherwise, you will always get a busy signal.

9.If you selected the FXO interface and are using touchtone dialing, you can set up the DTMF gain (or output level in decibels - dB) for the higher and lower frequency groups of the DTMF tone pair. Make your selections from the lists in the DTMF Gain group. In the Duration box, enter the DTMF tone duration in milliseconds. 100 is entered by default.

Note: Only change the DTMF gain under the direction of Multi-Tech Technical Support.

10.The Fax group enables you to send and receive faxes on the selected voice/fax channel. You can select the

33

Image 33
Contents Quick Start Guide Patents Quick Start GuideContents MultiVOIP IntroductionRelated Documentation Configure and Install Your Host MultiVOIP Installing Your MultiVOIPIntroduction Deploy the Voip Network Unpacking Your MultiVOIP Safety WarningsCable Connections Cabling Your MultiVOIPMultiVOIP Quick Start Guide M Jumper Block Positions Jumper Block Positioning ProcedureMultiVOIP Quick Start Guide Configuring Your Host MultiVOIP MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Page MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Configure Host MultiVOIP MultiVOIP Quick Start Guide Configuring Your Client MultiVOIPs MultiVOIP Quick Start Guide Configure Client MultiVOIPs MultiVOIP Quick Start Guide Configure Client MultiVOIPs MultiVOIP Quick Start Guide Configure Client MultiVOIPs MultiVOIP Quick Start Guide Deploy Voip Network Deploying the Voip NetworkRemote Site Cable Connection Deploy Voip Network Limited Warranty Contacting Technical Support Technical SupportFCC Declaration Warranty and Regulatory Information S000336A