Cabling Your MultiVOIP

Cabling

Cabling your MultiVOIP involves making the proper Power, Command Port, phone system, and Internet connections. Figure 3 shows the back panel connectors and the associated cable connections. The following procedure details the steps necessary for cabling your MultiVOIP.

Before starting to cable your MultiVOIP, perform the E&M Jumper Block Positioning Procedure, which immediately follows the Cabling Procedure, if either voice/fax channel (1 or

2)will be connected to an E&M trunk that is a Type 1, 3 ,4, or 5 rather than a Type 2 (the default).

1.Connect the power supply to a live AC outlet, then connect it to the MultiVOIP as shown in Figure 3. The power connector is a 6-pin circular DIN connector.

Voice/Fax Channel 1			Voice/Fax Channel 2			Ethernet RS232	1

E&M	FXS	FXO				10Base-T Command	0
			FXO	FXS	E&M		Power

Voice/Fax Channel

1 & 2 Connections

E&M FXS FXO

PBX

PSTN

Power Connection

Command Port Connection

Network Connection

Hub

Figure 3. Cable Connections

2.Connect the MultiVOIP to a PC using the RJ-45 to DB9 (female) cable provided with your unit. Plug the RJ-45 end of the cable into the Command port of the MultiVOIP and connect the other end to the PC serial port you are using. See Figure 3.