Multi-Tech Systems MT5634ZPX-PCI-U manual Frequency Stability

Page 29

MultiModemZPX User Guide

B Technical Specification

Frequency Stability

±0.01%

 

Receiver Sensitivity

-43 dBm under worst-case conditions

AGC Dynamic Range

43 dB

 

Bus Type

PCI 2.1

 

Connectors

Two RJ-11 phone jacks, one microphone jack, and one speaker jack

Cables

One RJ-11 phone cable

 

 

Note: Any cables connected to the computer should be shielded to

 

reduce interference.

 

Diagnostics

Power-on self-test (POST) and local analog loop

Environmental

Temperature range 0°–50°C (32°–120°F); humidity range 20–90% (non-

 

condensing)

 

Storage Temperature

-10° to +85°C (14°–185°F)

 

Power Requirements

3.3 or 5 volt slot

 

Dimensions

1.8 cm wide × 14.7 cm long ￿× 12.2 cm high (0.7" × 5.8" × 4.8")

Operating Systems

Tested for use with Windows

98, NT, and 2000, and Linux (2.2.x

 

kernal).

 

Limited Warranty

2 years

 

29

Image 29
Contents MultiModem ZPX MultiModemZPX User Guide Warranty PatentsRecord of Revisions TrademarksContents MultiModemZPX User Guide Product Description IntroductionSafety Warnings InstallationWhat You Will Need We supplyInstall the MultiModemZPX in your Computer Line Connection Make the External ConnectionsPhone Connection Optional Microphone Connection OptionalChanging the Windows 98/Me COM Port Assignment Install the Modem DriverInstalling the Modem Driver in Windows 98/Me/2000/XP Verifying the Windows 98/Me Configuration Remote Access Setup Installing the Modem Driver in Windows NTVerifying the Windows NT Configuration Click Start Settings Control Panel. Double-clickModemsClick Start Settings Control Panel Verifying the Windows 2000 ConfigurationViewing System Resources Removing Previous Modems from WindowsAT Commands Configure the Modem for Your CountryClick Initial Setup and Country Selection Global Wizard UtilityInstall PhoneTools Basic Procedure Remote ConfigurationSetup To Change the Setup PasswordTo Change the Remote Escape Character Modem Does Not Respond to Commands TroubleshootingModem Cannot Connect When Dialing Modem Disconnects While Online Data Is Being Lost Modem Cannot Connect When AnsweringFile Transfer Is Slower Than It Should Be Modem Doesn’t Work with Caller ID There Are Garbage Characters on the MonitorFax and Data Software Can’t Run at the Same Time Voice Functions Don’t WorkSpeakerphone Test with voice option Click Cancel in the Connection Description dialog boxLoopback Test FCC Part 68 Telecom Appendix a Regulatory ComplianceFax Branding Statement FCC PartProtection Against Contact with TNV Circuit Canadian Limitations NoticeIndustry Canada New Zealand Telecom Warning Notice EMC, Safety, and R&TTE Directive ComplianceInternational Modem Restrictions South African NoticeBuild Number Appendix B Technical SpecificationsFrequency Stability Appendix C Upgrading the Modem Upgrade OverviewIntroduction Identify the Modem FirmwareExtract the Upgrade Files Download the Upgrade FileIdentify the Current Firmware Version Document and Clear Your Stored ParamentersRestore Your Parameters Upgrade the Modem’s FirmwareVendor id=11c1 Device id=480 PC portLinux portSelect Dialup Configuration Tool Using the Terminal Program Minicom to Verify OperationSelect RH PPP Dialer Calling the ISPBaseAddr x I/O NxNNNN InstallationMultiModemZPX User Guide Index