3-RAID Control-LCD
3.2 Delete Volume Set
Scroll to choose the Delete Existing Volume Set option. Select the RAID set number and volume set to delete and press ENT. At the subsequent confirmation screen, press ENT to confirm deletion.
3.3 Modify Volume Set
Use this option to modify an existing volume set attributes as described in the above section. To modify volume set attributes scroll to choose the “Modify Volume Set Attribute option” from the “RAID set system” function. Select the RAID set number to modify and press ENT. Select the volume set number that user want to modify and press ENT. The volume set attributes screen shows the volume set setting configuration attributes that was currently being configured. Select attribute to change and Press the ENT to modify the default value. Select attribute value and press the ENT to accept the selection value. Choose this option to display the properties of the selected Volume Set; you can modify all values except the capacity.
Note:
When a volume set is migrating from one RAID level to another, a volume set stripe size changes, or when a disk is added to a RAID set the volume state will change to migrating. During migration. The migration status will be displayed in the volume state area of the LCD display. No additional volume changes can be performed until migration completes.
3.4 Check Volume Set Consistency
To check volume set consistency from volume set system function, scroll to choose the “Check Volume Set Consistency” option. Select the RAID set number to check and press ENT. Select the volume set number to check and press ENT. At the subsequent confirmation screen, press ENT to start the volume set consistency check.
3.5 Stop Volume Set Consistency Check
To stop volume set consistency check from volume set system function, scroll to choose the “Stop Volume Set Consistency Check” and then press ENT.
3.6 Display Volume Set Information
To display volume set information, scroll to choose the “Display Volume Information” option and then press ENT. Select the RAID set number that user wants to show and press ENT. Select the volume set number to display and press ENT. The volume set attributes screen shows the volume set setting configuration value that was currently being configured. See this chapter, section
RAIDBank4 Owner’s Manual | 23 |