Milan Technology EFLHB0X00 Operation, Optionally Connect to Backplane, Through AUI Uplink

Optionally Connect to Backplane

THROUGH AUI UPLINK

NOTE: Refer to 5-4-3 rule (page 3) to keep network configuration within acceptable bounds.

50Ω Terminator

Earth Ground

50Ω Terminator

USING TRANSCEIVER

NOTE: Refer to transceiver documentation for detailed specifications and instructions.

1.Locate AUI uplink adapter installed at E-FL-HB-0x00 back. (See page 4.)

2.Locate IEEE 802.3 compliant transceiver with male AUI connector and with required network media connector.

3.Connect transceiver male AUI connector to the female AUI connector on E-FL-HB-0x00

4.Referring to transceiver documentation, connect transceiver network media connector to the network media.

USING DROP CABLE

NOTE: In a coax thicknet installation, each 10BASE-5 cable end must be terminated using a 50 ohm terminator. Additionally, the 10BASE-5 segment must be grounded to “earth ground” at one end.

1.Locate AUI uplink adapter installed at E-FL-HB-0x00 back. (See page 4.)

2.Locate or build IEEE 802.3 compliant AUI drop cable. (See page 14.)

3.Connect AUI drop cable male connector to female AUI (DTE) connector on E-FL-HB-0x00

OPERATION

Use the status LEDs to monitor E-FL-HB-0x00 operation in the network.

BB				10BASE-FL
PWR	STAT
COL	ACT
		1	2	3	4	5	6	7	8
E-FL-0X00 HUB INDICATORS
	P(o)W(e)R	Steady LED indicates E-FL-HB-0x00 is
		connected to external AC power.
COL(lision)		Flashing LED indicates network collisions.
B(ACK)B(ONE) INDICATORS
STAT(us)		Steady LED indicates, for network
		connection, a valid link and no partition or
		isolation.

	One (1) continuous, flashing blink indicates
	network link is down.
	Two (2) continuous, flashing blinks indicate
	reception of Far End Fault (if fiber uplink
	adapter is installed and LINKAlert™ is
	enabled) OR port is partitioned (if AUI or
	BNC or fiber uplink adapter with
	LINKAlert™ not enabled is installed).
ACT(ivity)	Flashing LED indicates reception of network
	data packet(s).
10BASE-FL INDICATORS
STAT(us)	Steady LED indicates, for each port, a valid
	link and no partition or isolation.
	One (1) continuous, flashing blink indicates
	link is down.
	Two (2) continuous, flashing blinks indicate
	port is partitioned.
ACT(ivity)	Flashing LED indicates, for each port,
	reception of data packet(s).