MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem user manual

Page 2

The information contained in this manual has been validated at the time of this manual's production. The manufacturer reserves the right to make any changes and improvements in the product de- scribed in this manual at any time and without notice. Consequently the manufacturer assumes no liability for damages incurred directly or indi- rectly from errors, omissions or discrepancies be- tween the product and the manual.

All registered trademarks are the property of their respective owners.

Copyright © 1997 All rights reserved. No reproduction of this document in any form is permitted without prior written authorization from the Manufacturer.

Image 2

Contents 56K BPS Page Unpacking Your Modem Section Two InstallationSection One Introduction Hardware Installation Proceed to .3 now if you have every- thing requiredHardware Configuration Plug and Play Configuring in WindowsWindows 95 Release Windows 95 Release 4.00.950 BSoftware Installation and Configuration Configuring in a Plug and Play System with- out WindowsWhere To Go From Here Testing Your Modem After InstallationUsing Your Modem Command Structure Section Three AT Command SetExecuting Commands Basic AT CommandsLow speaker volume B1 Bell modeCommands are echoed Enable Autoscan modeExtended AT Commands MNP/V.42/V.42bis Commands \Bn \A1Size \J0Fax Class 1 Commands Fax Class 2 CommandsSVD Commands Section Four S Registers S RegistersSection Five Result Codes Section Six TroubleshootingModem does not respond to commands Section Seven Support and Service Appendix a SpecificationsAppendix B Notices FCC ComplianceEmentSatFBClas DOC Compliance InformationCeNotiUL