A1, Size | MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem

		compression
	%C1	Enable MNP Class 5 data compression
		only
&Q_	&Q0	Direct data link only (same as \N1)
	&Q5	V.42 data link with fallback options
	&Q6	Normal data link only (same as \N0)
\A_	\A0	64-character maximum MNP block size
	\A1	128-character maximum MNP block
		size
	\A2	192-character maximum MNP block size
	\A3	256-character maximum MNP block size
\Bn	Send a 1/10 second line break to the modem,
	where n = 1 to 9. At normal connect, the default
	is 3
\J_	\J0	DTE speed is independent of modem
		connect speed
	\J1	DTE speed matches the modem connect
		speed
\Kn	Set break control, where n= 0 to 5. The effect of
	this command depends on the modem’s
	operating condition. Default is 5.
\N_	\N0	Normal data-link only
	\N1	Direct data-link only
	\N2	MNP data link only
	\N3	V.42/MNP/Normal data link
	\N4	V.42 data link only
	\N5	V.42/MNP/Normal data link
	\N7	V.42/MNP/Normal data link
\Q_	\Q0	Disable flow control
	\Q1	XON\XOFF flow control
	\Q3	RTS\CTS flow control
\Tn		Inactivity timer (n=0-255 minutes)
\V_	\V0	Disable error correction protocol result
		code
	\V1	Enable error correction protocol result
		code
	\V2	Enable error correction protocol result
		code
\X_	\X0	If XON/XOFF flow control is enabled,
		do not pass XON/XOFF to remote
		modem or local DTE
	\X1	If XON/XOFF flow control is enabled,

\A1