MaxTech Plug & Play Internal Voice/FAX/Data/SVD Modem Software Installation and Configuration

Page 7

2.4.2Configuring in a Plug and Play System with- out Windows 95

When this modem is installed in a Plug and Play system without Windows 95, the computer's BIOS will assign a COM port and IRQ line to the modem.

Proceed to Section 2.5, Software Installation/ Configuration.

2.5 Software Installation and Configuration

You are now ready to install and configure the communication software. Refer to your software manual for installation procedures.

We suggest the following communication param- eters when you first use your data communication software. Consult the software manual for information on using these and other parameters/features.

57,600 bps; 8 data bits; no parity; 1 stop bit; RTS/CTS flow control set to “on;” initialization string: AT&F

We suggest that a “Generic Class 1” or “Ge- neric Class 2” modem type should be selected in your fax software, and a “Lucent” modem type should be selected in your Voice software.

Note that your software must be configured to communicate with the modem on the same COM port and IRQ line used by the modem.

2.6Using the Fax, Voice, SVD, and Speakerphone Capabilities of the Modem

Your modem has built-in advanced FAX, Voice, SVD, and Full Duplex Speakerphone functions. Please consult your FAX/Voice/SVD/Speakerphone software manual about procedures on using these features.

Speakerphone functions require a correctly con- figured sound card with attached microphone and speaker.

Voice functions include recording and playback of voice prompts (files). You may record or playback voice with your modem by attaching a telephone to the

5

Image 7
Contents 56K BPS Page Section One Introduction Section Two InstallationUnpacking Your Modem Proceed to .3 now if you have every- thing required Hardware InstallationConfiguring in Windows Hardware Configuration Plug and PlayWindows 95 Release 4.00.950 B Windows 95 ReleaseConfiguring in a Plug and Play System with- out Windows Software Installation and ConfigurationUsing Your Modem Testing Your Modem After InstallationWhere To Go From Here Basic AT Commands Section Three AT Command SetExecuting Commands Command StructureEnable Autoscan mode B1 Bell modeCommands are echoed Low speaker volumeExtended AT Commands MNP/V.42/V.42bis Commands \J0 \A1Size \BnFax Class 2 Commands Fax Class 1 CommandsSVD Commands S Registers Section Four S RegistersModem does not respond to commands Section Six TroubleshootingSection Five Result Codes Appendix a Specifications Section Seven Support and ServiceFCC Compliance Appendix B NoticesDOC Compliance Information EmentSatFBClasCeNotiUL