Link electronic Wireless 802.11g AP Router user manual Enable, Port Triggering

Page 29

Enable

Click the Enable checkbox to enable port forwarding for the application.

 

Port Triggering is used for special Internet applications whose outgoing ports differ from the

 

incoming ports. For this feature, the Router will watch outgoing data for specific port numbers.

 

The Router will remember the IP address of the computer that sends a transmission requesting

 

data, so that when the requested data returns through the Router, the data is pulled back to the

 

proper computer by way of IP address and port mapping rules. Click the Port Triggering button

 

to set up triggered ports, and follow these instructions:

 

1.

Enter the Application Name of the trigger.

Port Triggering

2.

Enter the Outgoing Port Range used by the application. Check with the Internet application

 

 

 

for the port number(s) needed.

 

3.

Enter the Incoming Port Range used by the application. Check with the Internet application

 

 

for the port number(s) needed.

 

4.

Click the Apply button to save your changes. Click the Cancel button to cancel your

 

 

unsaved changes. Click the Close button to return to the Port Forwarding screen.

Check all the settings and click Apply to save them.

User’s Guide

28

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Wireless 802.11g AP Router Copyright Statement Contents Introduction Safety Notification PWR/STAT Hardware InstallationTurn on Power Supply Web Management SettingsMake Correct Network Settings of Your Computer Primary Setup∙ Default Gateway Dynamic IP Setting Static IP Address∙ User Name and Password Internet IP Address and Subnet MaskUser’s Guide Algorithms WPA-Preshared keyWPA Shared KeyServer Port Default port being used is Please input the Authentication port of your Radius serverRadius server will accept the authentication if both Please choose your algorithms method. You can selectSecurity User’s Guide System To upgrade the Router’s firmwareClick More Info For Windows 98 and MillenniumUser’s Guide 192.168.1.100 Dhcp ServerUser’s Guide Snmp Status Advanced Wireless Authentication Type User’s Guide Access Filters To create or edit a policy, follow these instructions Internet Access PolicySummary User’s Guide Virtual ServerPort Triggering EnableDynamic Routing Routing TableStatic Routing, DestinationShow Routing Table Delete This Entry Click the Delete This Entry buttonClick the Show Routing Table DynDNS.org Dynamic DNSMy Wireless AP Router will not turn on. No LED’s light up TroubleshootingLAN Connection Problems I can’t access my AP Router Basic FunctionsUser’s Guide
Top Page Image Contents