Important Safety Instructions

SAVE THESE

INSTRUCTIONS

This manual contains important instructions that should be closely followed during installation and maintenance of this UPStation GXT 6kVA Maintenance Bypass.

This product is designed for commercial / industrial use only. This product is not intended for use with life support and other designated “critical” devices. Maximum load must not exceed that shown on the Maintenance Bypass Cabinet rating label.

! CAUTION

To reduce the risks of fire, connect only to a circuit provided with maximum branch circuit overcurrent protection of 40A in accordance with applicable national and local electrical codes.

Install the bypass equipment in a clean environment, free of conductive contaminants, moisture, flammable liquids, gases, and corrosive substances.

! WARNING

LETHAL VOLTAGES MAY BE PRESENT WITHIN THIS UNIT EVEN WHEN IT IS APPARENTLY NOT OPERATING. OBSERVE ALL CAUTIONS AND WARNINGS IN THIS MANUAL. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY OR DEATH. NEVER WORK ALONE.

The UPStation GXT 6 kVA Maintenance Bypass is designed for use on properly grounded (earthed) 208/240VAC 60Hz supply, for installation by qualified personnel. This UPS equipment is intended to be installed by a qualified / certified electrician who must review and approve customer supplied wiring, circuit breakers, intended loads and verify correct input, output and grounded (earth) connections to ensure compliance with technical standards and national and local electrical codes. Installation instructions and warning notices are in the Cable Installation section of this manual beginning on page 6.