Lantronix A104 manual

Page 6

-Tone detection for low power mode

-Supports splitter less ADSL implementation

-Supports Dying Gasp

-Interoperable with all major DSLAM equipment

ATM Protocols

-WAN mode support: PPP over ATM (RFC 2364) and PPP over Ethernet (RFC 2516)

-LAN mode support: bridged/routed Ethernet over ATM (RFC 1483) and classical IP over ATM (RFC 1577)

-ATM Forum UNI 3.1/4.0 PVC

-Up to 8 VCs (virtual circuits)

-ATM SAR (segmentation and reassembly)

-ATM AALC (adoption layer type 5)

-OAM F4/F5

Bridge Mode

-Ethernet to ADSL self learning Transparent Bridging (IEEE 802.1D)

-Supports up to 128 MAC learning addresses

Router Mode

-IP routing-RIPv2

-Static routing

-DNS Proxy

-Port Forwarding

-DHCP (dynamic host configuration protocol) server and client

-NAT (network address translation)

-MAPT (network address and port translation)

-ICMP (Internet control message protocol)

-Simultaneous USB and Ethernet operation

Security

-User authentication for PPP

-PAP (password authentication protocol)

-CHAP (challenge authentication protocol)

-Password protected system management

Ethernet Interface

- Compliant with IEEE 802.3 and 802.3u 10/100 Mbps

HTTP Web-Based Management

-Firmware upgrade via FTP

-Customizable Web pages

Image 6
Contents FCC Part Introduction Appendix a Glossary Page Page Page Page Page OFF 1 and 2-3.2 shows how to connect all cables to the Router Page Page VPI/VCI Page Page Page Page Page Page Page ISP Page PVC PVC Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Allows the user to set all the miscellaneous configurations Page Page Page Page Page Page Shows the events triggered by the system Page Page Page Page Page Page Page Page TAIPEI, TAIWAN, R. O. C