Intellinet Network Solutions 503679 user manual Configuration

Page 12

4.Click “Update” and “Reboot.” The Operation Mode screen should appear as below.

5.Repeat Steps 1–4 for the second AP you are bridging to.

6.From the Status menu on AP1 (bridge) and AP2 (bridge), go to the Association

Status screen to verify that the two are associating. If so, AP1 (bridge) and AP2 (bridge) are ready to be placed in permanent locations. Note: In Bridge mode, both APs must be on the same channel. The MAC address of AP1 (bridge) must be in the Remote MAC Address list of AP2 (bridge) and the

12 CONFIGURATION

Image 12

Contents Wireless Super G Page Package Contents IntroductionTable of contents Regulatory Statements FCC CautionFCC Radiation Exposure Statement European Union NoticeGround VentPoE Basic ip networking CONfiguraTION Basic AdministrationBasic Site Survey Basic IP Configuration Basic Operation ModeAP Repeater Mode Wireless Bridge Mode Configuration Advanced Radio Setting Advanced Security Setting WEP SecurityWPA-PSK Security WPA SecurityAdvanced MAC Address Control Advanced Protocol FilterAdvanced Snmp Configuration Advanced MiscellaneousStatus System Status Super User Firmware Upgrade Status Association StatusSuper User Super User Super User Firmware VersionUtility installaTION & operation Software InstallationOperation PC RequirementsInstallation Reminders Specifications WirelessStandards GeneralPower LEDsCertifications Environmental