Software Installation

utility installaTION & operation

The Wireless Super G Outdoor PoE Access Point and Bridge (“Outdoor AP”) utility is easy-to-use software that lets an administrator quickly configure the AP at first boot-up. The utility only communicates with authorized access points and bridges, allowing them to be monitored and configured even if they all have the same default IP address at first boot-up after installation.

PC Requirements

•X86-based CPU, 600 Mhz or above

•128 MB RAM

•1.5 MB hard disk space

•Ethernet port / wireless LAN adapter

•Windows 2000 or above

1.Double-click on the file “setup.exe” to display the utility’s InstallShield Wizard Welcome screen. Click “Next” to continue.

2.With the Destination Folder screen displayed, click “Next” to accept the default installation directory. To change the installation directory, click “Change” and select a new directory.

3.With the Ready to Install the Program screen displayed, click “Install” to begin the utility installation. An Installing Outdoor AP Utility status screen displays.

4.When the InstallShield Wizard Completed screen displays, click “Finish.”

Operation

Once the utility has been installed, you can click on its desktop icon to start the application. Several parameters will be displayed that can be modified.

NOTE: If the username and/or password of the devices has been changed, the utility needs to be updated with the correct username and/or password; otherwise, the utility will not operate properly. Any changes are made directly in the fields displayed on the utility screen.

Additionally:

•It doesn’t matter whether or not all the devices have the same IP address: The utility identifies them by their MAC addresses.

UTILITY INSTALLATION & OPERATION	19