Basic: IP Configuration
This screen allows you to select the IP Mode.
Static IP — When you boot up the AP for the first time, it is in Static mode, and you assign a static IP. The default IP address, subnet mask and gateway mask are 192.168.10.100, 255.255.255.0 and 0.0.0.0.
Dynamic IP (DHCP Client) — The AP will obtain an IP address from an upstream DHCP server. When in this mode, values obtained from the network are displayed.
Basic: Operation Mode
Operation Mode — The Wireless Super G Outdoor PoE Access Point and Bridge can operate in one of four modes: Access Point, Client, Wireless Repeater or Ethernet Bridge. (Steps for configuring the device as a repeater or bridge are presented below.) Bridge mode is used when it is not advisable to lay an Ethernet line over a long distance. Instead, two APs can be set up to connect over this distance, acting as the wired backbone.
SSID — The default service set identifier is 11g.
CONFIGURATION 9