Intellinet Network Solutions 503679 user manual Ground, Vent, PoE

Page 6

HARDWARE/CONNECTIONS

The components, connections and indicators depicted in the image (and directly corresponding to the unit itself) are detailed below as they appear from left to right. In addition, there are four holes on the rear panel of the device (the underside, as shown here) for attaching either of the included mounting brackets.

Ground

Use the included ground wire to ground the device.

Vent

This special Gore membrane vent protects the device by allowing any water

moisture to escape while preventing excess moisture from entering. No

adjustments are necessary.

PWR

This LED lights green whenever the device is receiving power.

WLAN

This LED flashes blue during LAN activity.

RESET

To return any settings to factory defaults, unscrew the dust cap and press the

button for five seconds or more.

EXT

If you require a higher-gain external antenna, unscrew the dust

cap and make your connection. The EXT connector features a mechanical switch function that automatically disables the built-

in 9-dBi directional antenna and redirects the RF signal to the external antenna. Conduct any signal alignment from the

external antenna. NOTE: Do not use the EXT connector for any other purpose, as doing so could interfere with the sophisticated mechanical switch inside the device. If the

cable used for an external antenna connection includes a

built-in surge protector, connect the shorter side of the cable to the Wireless Super G Outdoor PoE Access Point and Bridge.

PoE

External

Antenna

Model 503679

Surge

Protector

Unscrew the dust cap and connect the AP/bridge to the included PoE injector.

6 HARDWARE/CONNECTIONS

Image 6
Contents Wireless Super G Page Package Contents IntroductionTable of contents FCC Radiation Exposure Statement Regulatory StatementsFCC Caution European Union NoticeGround VentPoE Basic ip networking CONfiguraTION Basic AdministrationBasic Site Survey Basic IP Configuration Basic Operation ModeAP Repeater Mode Wireless Bridge Mode Configuration Advanced Radio Setting WPA-PSK Security Advanced Security SettingWEP Security WPA SecurityAdvanced MAC Address Control Advanced Protocol FilterAdvanced Snmp Configuration Advanced MiscellaneousStatus System Status Super User Super User Super User Firmware UpgradeStatus Association Status Super User Firmware VersionOperation Utility installaTION & operationSoftware Installation PC RequirementsInstallation Reminders Standards SpecificationsWireless GeneralCertifications PowerLEDs Environmental