Mode: Automatic mode and manual mode on/off. In Manual mode, you can define the connection speed. Auto is the default and recommended mode.
Speed: When in Manual mode, you can define the port speed here: either 10 Mbps or 100 Mbps.
Apply: Apply current settings.
Link Information: This section displays link status.
Port: The router’s WAN and LAN ports.
Link: Port is in use (on) or not connected (off).
Speed: Current port speed: 10 or 100 Mbps.
Duplex: Full or half duplex.
Link Statistics: Detailed traffic statistic for each port.
NOTE: Save the router configuration after completion; otherwise, the configuration will be lost after the router is restarted.
4.6.4 Routing Table (for advanced users only)
Click “Basic setup” ➝ ”Routing Table” to set up static routes:
Type: Routing Type NET or Host.
Target: Enter the IP address of the specified network or host you want to access using the static route.
Mask: Enter the subnet mask to be used for the specified network; e.g., 255.255.255.0 => 24.
Gateway: Enter in the gateway IP address for the specified network.
To save the new routing rule, click on the “Add” button. To delete a routing rule, check the selection box behind the entry and click on the “Del” button.
31