Accessing the Graphical Management Interface

2.Using the instructions that accompanied the card, verify that the card is properly activated and functioning correctly prior to installing the car into the JBM Gateway:

•Install the software that came with the aircard on a laptop.

•Install the aircard into the laptop.

•Follow the carrier provided procedures to properly activate the card, and unlock the card if necessary.

•Using the browser on the laptop insure that you are able to browse the Internet.

3.Resolve any and all signal/reception related issues with the aircard installed in the laptop before installing the card into the JBM Gateway.

4.Gently, insert the Aircard into the PCMCIA slot. Be sure it is firmly seated.

5.Attach power supply connector to C130 and connect power supply plug to an AC power outlet.

6.Verify the PWR (yellow) LED is lit to indicate that the unit is receiving power.

7.Establish access to the unit through Gateway Administration Utility.

Accessing the Graphical Management Interface

Step 1: Connect PC to JBM Gateway

METHOD – 1 ETH0: (Straight Ethernet Port)

•Connect a crossover CAT-5 Ethernet cable between the local PC and the JBM unit’s ETH0. Verify the link LED is lit. (Straight cable from a HUB/Switch).

METHOD 2 - ETH1:(Crossed-over Ethernet Port)

•Connect straight CAT-5 Ethernet cable between the local PC and the JBM unit’s ETH1. Verify the link LED is lit. (Crossover cable for HUB/Switch).

Port	Cable	Device
Straight (ETH0)	Straight	HUB or Switch
Straight (ETH0)	Crossed	PC
Crossed (ETH1)	Straight	PC
Crossed (ETH1)	Crossed	HUB or Switch

Page -4-