Cellular Card Configuration

Your JBM Gateway is able to detect many cellular cards, but others must still be configured manually. If you are using either one of the older 1xRTT/CDMA cards, or a GPRS/EDGE/HSDPA card that requires the use of a userid, password, and APN, you will need to configure your car manually, as covered in the next section.

If you are using any of these cards you will need to work through this section:

GPRS/Edge/HSDPA

Sierra Wireless: 750, 775, 860

Sony Ericsson: GC-83

If you are using one of the newer 1xRTT/1xEVDO, USB Serial based cards, your JBM gateway has probably automatically detected, configured, and activated your cellular connection for you, so you can skip this section and proceed to the next section to verify your cellular connectivity.

If you are using any of these cards you can skip this section:

1xRTT/1xEVDO Audiovox/UTSStarcom: 5740 Kyocera: KPC-650Novatel: S/V-620,S/V-720Sierra Wireless: 555, 580, 5220

Navigate through the GAU menus to the screen Cellular Configuration Screen shown below:

Page -9-