JBM electronic C-130 Access JBM Webserver, Log into the Graphical Administration Utility GAU

Page 8

•METHOD 1 should display an IP of 192.168.0.2

•METHOD 2 should display an IP of 192.168.1.2

Step 3: Access JBM Webserver

•Open a web browser and enter the following in the address bar: METHOD 1: http://192.168.0.1:10000/

METHOD 2: http://192.168.1.1:10000/

Step 4: Log into the Graphical Administration Utility (GAU)

JBMgateway Login Instructions

•User Name enter: jbmadmin ( lowercase letters)

•For Password enter: six digit serial number of unit (lowercase letters)

Upon successfully logging in you will be rewarded with the following screen:

•At this point, you are connected to the Gateway. You can now configure the unit to meet your needs.

Page -8-

Copyright ©2007 JBM Electronics, Inc.

Image 8

Contents 130 Quick Start Guide Table of Contents Unpacking Instructions PreparationAccessing the Graphical Management Interface Connect PC to JBM GatewaySetup PC IP Address Method 1 PC to ETH0 Method 2 PC to ETH1 Access JBM Webserver Log into the Graphical Administration Utility GAUCellular Card Configuration Cellular Carrier Selection Select the Aircard you are using Verify Cellular Connectivity Set the Userid, password and APNSave and Apply the Configuration Cellular Connectivity Troubleshooting Cellular ReceptionVerifying IP Connectivity Authentication Issues Minimal ReceptionJBM Technical Support Specifcations Software Licensing Terms and Conditions Information To The UserWarranty Extended Warranty Program