JBM electronic C-130 quick start Setup PC IP Address

Page 5

Note: This example shows cabling to a PC. The link LED is not lit for ETH1. Without a link LED lit either Method 1 must be used or the cabling must be checked.

Step 2: Setup PC IP Address

Set the PC’s IP Address by going to control panel and selecting network connections, the screen below will appear:

•Right Click “Local Area Connection” and select “Properties” (as shown to the left).

Page -5-

Image 5

Contents 130 Quick Start Guide Table of Contents Preparation Unpacking InstructionsConnect PC to JBM Gateway Accessing the Graphical Management InterfaceSetup PC IP Address Method 1 PC to ETH0 Method 2 PC to ETH1 Log into the Graphical Administration Utility GAU Access JBM WebserverCellular Card Configuration Cellular Carrier Selection Select the Aircard you are using Verify Cellular Connectivity Set the Userid, password and APNSave and Apply the Configuration Cellular Reception Cellular Connectivity TroubleshootingVerifying IP Connectivity Minimal Reception Authentication IssuesJBM Technical Support Specifcations Information To The User Software Licensing Terms and ConditionsExtended Warranty Program Warranty