Hawking Technology HNAS1 manual Follow the Setup Wizard to Complete Installation Power On

Page 20

2: Follow the Setup Wizard to Complete Installation

Power On

Connect the power cord and press the “Power” button on the front panel of the Network Storage Center.

Ensure that the “Power” LED is lit green.

Note: To power off the device, hold down the “Power” button for at least five seconds until the “Power” LED starts blinking and then turns off.

20

Image 20

Contents Page Hawking Limited Warranty FTP Smart Wizard Powerful and EasyKey Features Unpack and Inspect Power Button LED DefinitionsConfiguring the Network Protocols How to Configure the TCP/IP Network ProtocolClick on Start-Settings-Control Panel-Network Windows 98/MeClick IP Address and click on Specify IP Address Windows Page Windows XP Page Page Click on View Network Connections Default Gateway line. These two How to Connect Your Hard Drive to the Network Storage Center IDE ConnectorPower Connector Activate The Utility Software WelcomeFollow the Setup Wizard to Complete Installation Power On ƒ Ensure that the Link/Act LED is lit green LAN ConnectionPage Reachable Status Action Hard Drives FoundUser name/Password Reminder SettingsPlease read this carefully Click OK to set up your Network Storage Center Icons CreatedPage Set Up the Network Storage Center Configuration HomepageNetwork Storage Center’s Homepage StatusStatus Details Network Settings Host NameConfiguration IP AddressSuperuser/Password Administration Restart SystemHD Format Factory Default Reset Firmware UpgradeSystem Time Character SetUser configuration SharePage Delete User Folder Configuration Add FolderDelete Folder Change the User Authentication for a Folder FTP Configuration FTPFTP Password Page Page Page Multiple Users Backup Individual UserRemote Backup FTP How do I shut down the Network Storage Center properly? Cannot access the Network Storage Center Diagnostic LEDs DimensionsOperating Temperature Power Supply