Hawking Technology HNAS1 manual Factory Default Reset, Firmware Upgrade

Page 36

Factory Default Reset

To restore the Network Storage Center to its default configuration, click “Yes” (see figure below). Do not power off the device before the system is ready.

Firmware Upgrade

To upgrade the Firmware:

1.Click Browse…

2.Select the firmware file you want to you for the upgrade process.

3.Click Apply

Caution: Do not power off the device during the upgrade process, as this could damage it.

Image 36

Contents Page Hawking Limited Warranty FTP Powerful and Easy Key FeaturesSmart Wizard Unpack and Inspect Power Button LED DefinitionsConfiguring the Network Protocols How to Configure the TCP/IP Network ProtocolClick on Start-Settings-Control Panel-Network Windows 98/MeClick IP Address and click on Specify IP Address Windows Page Windows XP Page Page Click on View Network Connections Default Gateway line. These two How to Connect Your Hard Drive to the Network Storage Center IDE ConnectorPower Connector Activate The Utility Software WelcomeFollow the Setup Wizard to Complete Installation Power On ƒ Ensure that the Link/Act LED is lit green LAN ConnectionPage Reachable Status Action Hard Drives FoundUser name/Password Reminder SettingsPlease read this carefully Click OK to set up your Network Storage Center Icons CreatedPage Set Up the Network Storage Center Configuration HomepageNetwork Storage Center’s Homepage StatusStatus Details Network Settings Host NameConfiguration IP AddressSuperuser/Password Administration Restart SystemHD Format Factory Default Reset Firmware UpgradeSystem Time Character SetUser configuration SharePage Delete User Folder Configuration Add FolderDelete Folder Change the User Authentication for a Folder FTP Configuration FTPFTP Password Page Page Page Multiple Users Backup Individual UserRemote Backup FTP How do I shut down the Network Storage Center properly? Cannot access the Network Storage Center Diagnostic LEDs DimensionsOperating Temperature Power Supply