Front Panel
Power Button
To activate the Network Storage Center, press this Power button located on the front panel of the device. To power off the unit, press the Power button for two seconds until the Power LED starts to blink.
LED Definitions |
|
| |
|
|
|
|
| LED | Status |
|
| Power | ON /OFF | Green/Dark |
|
| Boot/Shutdown: | Blinking |
| Link/ACT | Ethernet Connected | Green |
|
| Ethernet Not Connected | Dark |
|
| Ethernet Data Transfer | Blinking |
| HD | Hard Drive Data Transfer | Amber/Blinking |
Rear Panel
Reset Button
To restore the default settings, use the tip of a ballpoint pen or paper clip to hold this button down for at least five seconds. This will cause the default reset to begin.
Ethernet Port
Use an
Power Supply
External power adapter:
DC 12V/3A.
6