Hawking Technology HNAS1 manual Activate The Utility Software, Welcome

Page 19

If you are using the Network Storage Center for the first time, the Setup Wizard will provide you with a simple and easy way to set up the device. The Setup Wizard will guide you through the connections of the necessary cables as well as the settings for network configuration.

Note: In the Setup Wizard, as well as the Network Storage Center’s web user interface, you will frequently see the term “Network HD”. It is interchangeable with the term “Network Storage Center” and both are used to describe the HNAS1. Please note, however, that “Network HD” is different from the term “HD” or “hard drive”. “HD” or “hard drive” is used to describe a basic 3.5” IDE hard drive, not the Network Storage Center.

Please follow the steps outlined below:

1: Activate The Utility Software

Place the utility CD (included with the HNAS1 package) into your CD-ROM drive and wait for the Auto- run menu to appear on your screen. Then click on Quick Setup Wizard. If the utility does not activate automatically, click the Start button in the lower left corner of your screen, select Run, type D:\autorun.exe (where D is the letter of your CD-ROM drive) into the open window and click Enter.

Welcome Page

ƒThe figure shown above is the Welcome page for the Quick Setup Wizard. Follow the program, as shown in the pages that follow, to complete the LED check, installation of basic cables, and network configuration.

ƒClick Next to continue.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Page Hawking Limited Warranty FTP Key Features Powerful and EasySmart Wizard Unpack and Inspect LED Definitions Power ButtonHow to Configure the TCP/IP Network Protocol Configuring the Network ProtocolsWindows 98/Me Click on Start-Settings-Control Panel-NetworkClick IP Address and click on Specify IP Address Windows Page Windows XP Page Page Click on View Network Connections Default Gateway line. These two IDE Connector How to Connect Your Hard Drive to the Network Storage CenterPower Connector Welcome Activate The Utility SoftwareFollow the Setup Wizard to Complete Installation Power On LAN Connection ƒ Ensure that the Link/Act LED is lit greenPage Hard Drives Found Reachable Status ActionSettings User name/Password ReminderPlease read this carefully Icons Created Click OK to set up your Network Storage CenterPage Set Up the Network Storage Center Status ConfigurationHomepage Network Storage Center’s HomepageStatus Details Host Name Network SettingsIP Address ConfigurationSuperuser/Password Restart System AdministrationHD Format Firmware Upgrade Factory Default ResetCharacter Set System TimeShare User configurationPage Delete User Add Folder Folder ConfigurationDelete Folder Change the User Authentication for a Folder FTP FTP ConfigurationFTP Password Page Page Page Individual User Multiple Users BackupRemote Backup FTP How do I shut down the Network Storage Center properly? Cannot access the Network Storage Center Power Supply Diagnostic LEDsDimensions Operating Temperature
Top Page Image Contents