Uniden UA466ZL manual Installation, Installing the Battery Pack

Page 9

WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page 7

Installation

Installing the Battery Pack

1.Use a coin or screw driver to loosen the screw on the cover.

2.Unlock both sides of the battery compartment.

3.Open the cover.

4.Connect the battery pack (BT-446) connector observing the correct polarity (black and red wires) to the jack inside the battery compartment. Do not exert any force on this connection. It could cause damage to the battery or handset.

The plastic connector will fit together only one way. Once you are certain that you have made a good connection, then insert the battery pack into the battery compartment. Do not pinch the wires.

5.Tighten the screw on the cover.

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents WHAMUA466ZL UA01466ZA0 9/20/02 1250 PM Page a Contents Precautions Introduction FeaturesWham Included with your WhamMicrophone Controls and IndicatorsMenu Display Mounting the Drop-in Charger Getting StartedInstalling the Battery Pack InstallationInstalling the Beltclip Control Unit Connection and Installation Power On/Off OperationTriple Watch Volume Adjusting Weather ChannelsMEM Entering channel numbers into Memory Scan Appears Registering the Wham to the PolarisLow Battery Alert Hail Volume adjustBacklight Adjust HailDistress To cancel the Distress call, press H/L/SELECTCare and Maintenance TroubleshootingGeneral SpecificationWarranty WHAMUA466ZL UA01466ZA0 9/20/02 1250 PM Page b
Top Page Image Contents