Uniden UA466ZL manual Troubleshooting, Care and Maintenance

WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page 15

Troubleshooting

If the WHAM does not perform to your expectations, try the suggestions listed below, If you cannot get satisfactory results, call Uniden Technical Support at (800) 586-0409, 8:00 a.m. to 5:00 p.m., Central Standard Time, Monday through Friday.

SYMPTOM	CAUSE	REMEDY
Won’t power On.	No or low voltage.	Check for proper voltage.
		Recharge or replace the
		batteries.
When the PTT is	Bad mic element.	Send in for repair.
pressed - TX icon
comes on and
another radio can
hear a “click” but no
audio is heard.
While scanning, the	A source of noise	Eliminate the source of
radio stops on a	is nearby.	the noise or delete the
particular channel all		channel from the
of the time.		Scan Memory.
There is noise on	An external noise is	Either turn off the
the receiver that the	being generated by	offending device or
squelch will not	some device.	contact that Mfg.
eliminate.		Regarding FCC part 15
		“unintentional radiator”.
WHAM won’t control	POLARIS is	Turn the POLARIS On.
the POLARIS.	turned Off.

Care and Maintenance

Your WHAM is a precision piece of electronic equipment and you should treat it accordingly. Due to the rugged design, very little maintenance is required. However, a few precautions should be observed:

•You are responsible for continued FCC technical compliance of your radio.

•You are urged to arrange for periodic performance checks with your Uniden Marine dealer.

15