WHAM_UA466ZL UA01466ZA_0 9/20/02 12:50 PM Page 12
Registering the WHAM to the POLARIS
Note: When you use the WHAM in addition to the POLARIS wired mic, please set the BASE ID for the POLARIS the same as the WHAM. (Please refer to the Owners Manual for the POLARIS).
1. When the WHAM is turned On for | Base | |
the first time, the following screen | ||
Hand set | ||
appears. | ||
|
2.Press ▲ to increase the number, or press ▼ to decrease the number. The number will be entered when
the H/L/SELECT is pressed, and the blinking digit moves to the right. (You can select any number between 0000 and 9999.)
3.After the Base ID is entered, the Handset ID blinks.
4.You can select the Hand set ID by pressing ▲ or ▼, and then press H/L/SELECT to enter the number.
5.Turn the WHAM Off to confirm the data.
Note: When the following screen appears, the transceiver may not have the correct Base ID or the WHAM is too far from the POLARIS. Confirm whether the Base ID is right. If the screen
does not change, move closer to the POLARIS. In order to register the WHAM to the POLARIS, you have to turn the POLARIS Off once. In case you need to rewrite the ID, you need to press and hold MENU/HAIL and turn the WHAM On. When you rewrite the ID, press and hold MENU/HAIL for
2 seconds and turn the WHAM On to change the Base ID and Handset ID.
*Please refer to the POLARIS’ Owners Manual for menu operation. The key names may vary.
12