GE Monogram Zenith Controls, ZTX manual How to Remove the Cover, Hazardous Voltage

Page 3

How to Remove the Cover

Loosen but do not remove four cover screws. Lift cover off the four screws and hang on two screws (2 bottom or 2 right-hand). See Figure i and ii.

This will prevent damage to the cable. The cable may also be disconnected at the controller or keypad.

NOTE: Reattach cable before installing cover.

DANGER

HAZARDOUS VOLTAGE

Will shock, burn or cause death. Do not remove cover until ALL power is disconnected.

Re-installation of cover is required after maintenance or service.

Figure i

Figure ii

GE Zenith Controls

ZTX Operation and Maintenance Manual (62R-2000)

1

Image 3
Contents GE Zenith Controls Authorized Service Table of ContentsIntroduction Hazardous Voltage How to Remove the CoverHazardous Voltage InstallationPower Connections Installation cont’dController Control ConnectionsBattery and Holder Battery Harness MX50/90 Controller Functional Test Functional TestOptional Indicator LEDs RM4 Control Interface OptionalOptional Pushbuttons RM4 Control Interface Optional cont’d Automatic Generator Exerciser Selecting Exerciser Without TransferSelecting Exerciser With Transfer Fuel/Run Contact Output Temperature Sensor InputGenerator Battery Input Oil Pressure Sensor InputPartial Coverage System Example SystemsTypical Diagrams Symptom Possible Cause Corrective Action TroubleshootingGenerator Fault Flash Table Troubleshooting cont’dPage GE Zenith Controls