GarrettCom DS80C, DS80F manual Fiber ST above, fiber SC at right

Magnum DS80F & DS80C Dual-speed Stackable Hubs Installation and User Guide (12/01)

2.2.1Magnum DS80F chassis with fiber ST or SC (mm or sgl. mode) connector

12V, 1.5Amps

Magnum DS80 Dual Speed

Personal Hub

		Power	Speed
		Error	Link/Act
	GARRETT			F/H
		PORTS		1SW	2SW	3	4	5	6	7	8
Tx	Rx	UPLINK		1SW		3	4	5	6	7	8
		UPLINK
		=	X
		F	H 2SW

Fiber ST above, fiber SC at right

12V, 1.5Amps

Magnum DS80 Dual Speed

Personal Hub

Power	Speed
Error	Link/Act
GARRETT	F/H
PORTS	1SW 2SW	3	4	5	6	7	8

Tx F	RxH		UPLINK		1SW	3	4	5	6	7	8
		UPLINK
		F	=	X
				H 2SW

The Magnum DS80F chassis

houses one main PC board. The power supply unit is external. The front side of the chassis has eight RJ-45 twisted-pair ports and one 100Mbps fiber port. Port #2SW always supports fiber ports only and the RJ-45 connector is inoperative at all times. LEDs to indicate operating status of all ports are mounted on the top. There are power (PWR) and ERROR (self-test at power up failed) indicators for the unit. For each port, there are Link and Activity (LINK/ACT) LEDs indicating traffic, and speed (ON for

PORTS	1SW 2SW 3 4 5 6 7 8 GARRETT
100Mbps). Switched ports 1SW and 2SW	F/H	Power
	Link/Act	Error
	Speed
have full-half (F-H) duplex indicators.	Personal Hub
	Magnum DS80F Dual Speed
		12V, 1.5Amps
The DC power plug connector or		DC 12V
“jack” is in the left rear of the chassis.	Rear View Magnum DS80-Series

The external power supply is 5VDC at either 95 - 125vac at 60 Hz for “-d” models or 120- 250vac at 50Hz for “-i” models that have IEC power cable connector in the external power supply housing.

2.2.2Magnum DS80C chassis with all RJ-45 Copper ports

									The Magnum DS80C chassis
		5VDC, 2Amps
		Magnum DS80 Dual Speed							houses one main PC board. The power
Power		Speed	Personal Hub
Error Link/Act									supply unit is external. The front side of the
GARRETT PORTS		F/H
		1SW	2SW 3	4	5	6	7	8
Tx Rx	UPLINK	1SW	3	4	5	6	7	8
UPLINK									chassis has eight RJ-45 twisted-pair ports.
F = XH		2SW
									The 1SW and 2SW ports are switched ports
with selectable Fullfixed- and Auto-negotiation (FF-A) capability. See section 4.4.

LEDs to indicate operating status of all ports are mounted on the top. There are power (PWR) and ERROR (self-test at power up failed) indicators for the unit. For each port, there are

Link and Activity (LINK/ACT) LEDs indicating traffic, and speed (ON for 100Mbps). Switched ports 1SW and 2SW have full/half (F/H ON for full duplex) duplex indicators.

www . GarrettCom . com

6