GarrettCom manual Locating Magnum DS80F & DS80C Dual-Speed Hubs, Table-Top or Shelf Mounting

Magnum DS80F & DS80C Dual-speed Stackable Hubs Installation and User Guide (12/01)

3.0INSTALLATION

This chapter provides instructions for installing Magnum DS80F and DS80C hubs.

3.1Locating Magnum DS80F & DS80C Dual-Speed Hubs

The location of a Magnum DS80F & DS80C Dual-Speed Personal Hub is dependent on the physical layout of the network. Typically the hub is located in a workplace site. The compact size of the unit allows it to be conveniently placed in an office, classroom or lab area, and it can also be either shelf- of wall-mounted (see mounting instructions in 3.1.2 below). Metal wall-mounting clips are included with the unit.

Locate an AC receptacle that is within six feet (2 meters) of the intended Magnum DS80F & DS80C site. The rugged metal case of the Magnum DS80F & DS80C will normally protect it from accidental damage in a lab or workplace setting. Maintain an open view of the top surface to visually monitor the status LEDs.

3.1.1Table-Top or Shelf Mounting

The Magnum DS80F & DS80C Dual-Speed Personal Hub can be easily mounted on a table-top or any suitable horizontal surface, and has four rubber feet to provide stability without scratching finished surfaces.

3.1.2	Wall (or vertical surface) mounting
	Each Magnum DS80F and DS80C
Personal Hub is shipped with two metal mounting
brackets (and screws) to allow the unit to be			Proper attachment of
			mounting bracket for wall mounting
	5VDC, 2A		mounted in nearly any desired orientation or
	Magnum DS80 Dual Speed
			position. The brackets are attached to the
		Personal Hub
			metal hub case using one of the metal screws
	Power	Speed	for each bracket and attaching to the Magnum
		Link/Act
	Error
		F/H
	GARRETT
			DS80F and DS80C through the round hole of
	PORTS 1SW 2SW 3 4 5 6 7 8
			the bracket. A user-supplied screw attaches
Top view - Magnum DS80F with			the bracket to the mounting surface. It is
brackets attached for wall mounting			recommended to use appropriate # 4 screws

for attaching mounting bracket to wall (e.g wood screw, self-tapping screw, machine screw). It is also recommended that the brackets be attached to two opposite corners of the unit. When

www . GarrettCom . com

12