Gefen GTB-MHDMI1.3-441 user manual IR Remote Control Unit Operation, Source RMT-4IR button

Page 14

IR REMOTE CONTROL UNIT OPERATION

The RMT-4IR remote control will allow selecting the source to display on the output. Each button on the remote control corresponds to one of the of four source inputs. Please use the information below when selecting the desired source:

Table of IR Remote Commands

for the GefenToolBox 4x1 Switcher for HDMI

RMT-4IR

 

Source

 

1

1

 

2

2

 

3

3

 

4

4

 

RMT-4IR button

 

Source

 

 

 

 

 

3

 

3

 

Example: In the above example, if button 3 on the RMT-4IR remote control is pressed, the source connected HDMI In 3 will be routed to the Display device.

11

Image 14
Contents Gefen GTB-MHDMI1.3-441Technical Support Hours Asking for AssistanceTechnical Support Write ToContents Introduction About Gefen Why GefenToolBox?GefenToolBox 4x1 Switcher for Hdmi How It WorksOperation Notes General Features FeaturesHdmi 1.3 Features Package IncludesPanel Layout Source Selector and Indicator LEDs Panel DescriptionsHow to Operate the GefenToolBox 4x1 Switcher for Hdmi Connecting and Operating Gefentoolbox 4X1 Switcher for HdmiHow to Connect the GefenToolBox 4x1 Switcher for Hdmi Automatic Switching Example 2 Routing Input source 3 to the Output displayIR Remote Control Unit Description Routing Sources to DisplaysBattery Slot IR Remote Control Unit InstallationInstalling the IR Remote Control Battery Resolving IR Code Conflicts IR Remote Control Unit ConfigurationDIP Switches IR Remote Control Unit Operation Source RMT-4IR button4x1 Switcher IR Extender InstallationUsing the IR Extender RS-232 Settings RS-232 Serial ControlCommand CommandsCommand Description V command displays the firmware version Changing the IR Channel Changing the IR channelWall Mounting Instructions Specifications 5V DCPage Page Page Rev A6 Nordhoff St., Chatsworth CA