Gefen GTB-MHDMI1.3-441 user manual Changing the IR Channel, Changing the IR channel

Page 19

CHANGING THE IR CHANNEL

Changing the IR channel

Use the following procedure to set the proper IR channel on the GefenToolBox 4x1 Switcher for HDMI.

1Press and hold the Input Select button for 5 seconds to enter IR channel selection mode. The bank of blue LED indicators will now display the currently selected IR channel.

2Press the Input Select button to cycle through each IR channel. The currently selected IR channel will by indicated by a flashing blue LED. IMPORTANT: The selected IR channel must be the same as the IR channel set on the IR Remote Control Unit (page 10). Refer to the table below for setting the IR channel.

3Once the proper IR channel has been selected, press and hold the Input Select button to confirm and exit IR channel selection mode. The currently selected input source will now be indicated.

IR Channel Table

Input LED

IR Channel

1

0

2

1

3

2

4

3

16

Image 19
Contents GTB-MHDMI1.3-441 GefenWrite To Asking for AssistanceTechnical Support Technical Support HoursContents How It Works About Gefen Why GefenToolBox?GefenToolBox 4x1 Switcher for Hdmi IntroductionOperation Notes Package Includes FeaturesHdmi 1.3 Features General FeaturesPanel Layout Panel Descriptions Source Selector and Indicator LEDsHow to Connect the GefenToolBox 4x1 Switcher for Hdmi Connecting and Operating Gefentoolbox 4X1 Switcher for HdmiHow to Operate the GefenToolBox 4x1 Switcher for Hdmi Example 2 Routing Input source 3 to the Output display Automatic SwitchingRouting Sources to Displays IR Remote Control Unit DescriptionInstalling the IR Remote Control Battery IR Remote Control Unit InstallationBattery Slot DIP Switches IR Remote Control Unit ConfigurationResolving IR Code Conflicts Source RMT-4IR button IR Remote Control Unit OperationUsing the IR Extender IR Extender Installation4x1 Switcher RS-232 Serial Control RS-232 SettingsCommand Description CommandsCommand V command displays the firmware version Changing the IR channel Changing the IR ChannelWall Mounting Instructions 5V DC SpecificationsPage Page Page Rev A6 Nordhoff St., Chatsworth CA