GE 45606 Observe Important Wiring Information, Instructions, Wire Connector / Combination Chart

GE 45606 manual Dimmer Switch GE 45606 manual Introduction GE 45606 manual Dimmer switch LED light Air gap switch GE 45606 manual Risk of Fire Risk of Electrical Shock Risk of Burns GE 45606 manual Wireless Range GE 45606 manual Type of Construction GE 45606 manual See diagram on next GE 45606 manual Single, Dual and Triple Gang Boxes GE 45606 manual White GE 45606 manual Shock Hazard GE 45606 manual Observe Important Wiring Information, Instructions, Wire Connector / Combination Chart GE 45606 manual Air Gap Switch, Key Features, Basic Operation, Manual Control GE 45606 manual Primary controller’s instructions for details GE 45606 manual LED Indicator, Advanced Operation, All On/All Off GE 45606 manual LED Light, Invert Switch, Dim Rate Adjustments GE 45606 manual Valid Values GE 45606 manual Restoring Factory Defaults, Warranty GE manual Fcc, U2Z45606-7, Operation is subject to the following two conditions GE 45606 manual Compliance with IC Rules and Regulations, Specifications GE 45606 manual
Page 11

Observe Important Wiring Information

Always follow the recommended wire strip lengths and wiring combinations when making wiring connections. Important: The wire connectors included with this dimmer are intended to only be used with copper wire. Consult a qualified electrician if you have aluminum wiring.

Instructions:

1.Strip insulation 3/8” for 12 or 14 AWG wire. Strip insulation 7/16” for 16 or 18 AWG wire.

2.Hold stripped ends together in parallel and align any frayed strands (do not twist wires).

3.Push wires firmly into connector. Twist connector clockwise with fingers until tight. Pull wires to check for tightness.

Wire Connector / Combination Chart

One #14 w/one-to-four #16 or #18

One #12 w/one-to-three #14 or #16 or #18

Two #14 w/one-to-three #16 or #18

Two #12 w/one or two #14 or #16 or #18

You should now be able to use the rocker to manually turn On/Off a lamp plugged into the Z-Wave controlled outlet.

Use your primary controller to include the dimmer switch in the home control network after the dimmer switch is wired as shown in the above diagram,. It can then be added to groups and/or lighting scenes and managed remotely to control the On/Off status and brightness level of the connected incandescent lighting.

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Dimmer Switch Introduction Dimmer switch LED light Air gap switch Risk of Fire Risk of Electrical Shock Risk of Burns Wireless Range Type of Construction See diagram on next Single, Dual and Triple Gang Boxes White Shock Hazard Instructions Observe Important Wiring InformationWire Connector / Combination Chart Manual Control Air Gap SwitchKey Features Basic OperationPrimary controller’s instructions for details All On/All Off LED IndicatorAdvanced Operation LED Light Invert SwitchDim Rate Adjustments Valid Values Warranty Restoring Factory DefaultsOperation is subject to the following two conditions FCCU2Z45606-7 Compliance with IC Rules and Regulations Specifications
Top Page Image Contents