GE 45606 manual Compliance with IC Rules and Regulations, Specifications

Page 19

Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.

Compliance with IC Rules and Regulations

IC: 6924A-45606A7

Jasco Products Company

Model: 45606

This Class B digital device complies with Canadian ICES-003.

SPECIFICATIONS

Power: 120 VAC, 60 Hz.

Signal (Frequency): 908.42 MHz.

Minimum Load: 40W, incandescent lamps only.

Maximum Load: 500W, incandescent lamps only.

Range: Up to 100 feet line of sight between the Wireless Controller and the closest Z-Wave receiver module.

Operating Temperature Range: 32-104° F (0-40° C) For indoor use only.

Specifications subject to change without notice due to continuing product improvement

Z-Wave is a registered US trademark of Zensys A/S

© 2007 JASCO Products Company

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Dimmer Switch Introduction Dimmer switch LED light Air gap switch Risk of Fire Risk of Electrical Shock Risk of Burns Wireless Range Type of Construction See diagram on next Single, Dual and Triple Gang Boxes White Shock Hazard Wire Connector / Combination Chart Observe Important Wiring InformationInstructions Manual Control Air Gap SwitchKey Features Basic OperationPrimary controller’s instructions for details Advanced Operation LED IndicatorAll On/All Off Dim Rate Adjustments Invert SwitchLED Light Valid Values Warranty Restoring Factory DefaultsU2Z45606-7 FCCOperation is subject to the following two conditions Compliance with IC Rules and Regulations Specifications
Top Page Image Contents