GE 45606 manual Air Gap Switch, Key Features, Basic Operation, Manual Control

Page 12

Air Gap Switch

During normal operation, there is a small amount of power passing through the switch to the load even when the dimmer switch is turned off. The 45606 has an air gap switch on the lower left side (see diagram for location) to completely disconnect power to the load. Pull the air gap switch OUT to disconnect the power while replacing light bulbs and push it all the way back in for normal operation. The air gap switch must be all the way in for the dimmer to function and control the lighting.

Key Features

-Remote On/Off/Brightness control via the Z-Wave controller/network

-Manual On/Off/Brightness control with the front panel rocker

-LED indicates switch location in a dark room

-Adjustable Dim rates

BASIC OPERATION

Remote Control

GE Z-Wave remotes provide control of an Individual device, Groups of devices and Scenes. Other brands of Z-Wave Certified remotes may not offer as much flexibility in how you can set up your lighting control network. Please refer to your remote control’s instructions for details on its capabilities and instructions for adding and controlling devices.

Manual Control

The 45606 dimmer switch allows the user to:

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Dimmer Switch Introduction Dimmer switch LED light Air gap switch Risk of Fire Risk of Electrical Shock Risk of Burns Wireless Range Type of Construction See diagram on next Single, Dual and Triple Gang Boxes White Shock Hazard Observe Important Wiring Information Wire Connector / Combination ChartInstructions Air Gap Switch Key FeaturesBasic Operation Manual ControlPrimary controller’s instructions for details LED Indicator Advanced OperationAll On/All Off Invert Switch Dim Rate AdjustmentsLED Light Valid Values Restoring Factory Defaults WarrantyFCC U2Z45606-7Operation is subject to the following two conditions Specifications Compliance with IC Rules and Regulations
Top Page Image Contents