Generac Power Systems R-200A technical manual Generac Power SYSTEMS, INC

Page 16

GENERAC® POWER SYSTEMS, INC.

P.O. BOX 8

WAUKESHA, WI 53187

Part No. 0G1341

Revision E (06/19/07)

Printed in U.S.A.

Image 16
Contents Technical Manual  General Hazards  Authorized Service Dealer Location Table of ContentsControl Board DIP Switch & Jumper Settings IntroductionDip Switch & Jumper Settings Old Revision Switch Position Condition System Low Utility Restored Generator OperationEngine Timing Utility FailureActive Alarm Normal Exercise ModeRE-CRANK Auto StartLOW Battery RED LED Indicator System Ready Green LED IndicatorLOW Fuel Pressure Yellow LED Indicator LOW OIL Pressure RED LED IndicatorRPM Signal Failure Flashing RED Overspeed Indicator Overcrank RED LED IndicatorAlarm Cancel Automatic Transfer Switch ATS ModeEngineered Transfer Switch 2-WIRE Start GTS Mode Voltage Regulator Adjustment Line NEU GND2A and 10A Battery Chargers ‹ R-200A J2 Connector 14 PIN White‹ 2A, 12VDC Battery Charger ‹ 10A, 12VDC Battery ChargerPanel Technical Manual Generac Power SYSTEMS, INC