Chapter 5
Application Integration Reference Guide
This chapter describes the deliverables required to build an 802.15.4/Zigbee Application with the Embedded Bootloader.
NOTE
The Freescale Switch Demonstration application is available with complete source code. The Switch Demonsration shows how to make an
802.15.4application with the Embedded Bootloader. Refer to the Switch Demonstration Application Note, AN2773, for more details.
5.1Product Deliverables
To be able to make an application with the Freescale Embedded Bootloader, you need three major components.
•Embedded Bootloader Image
•Application Support Files
•Application Linker File
5.1.1 Embedded Bootloader Image
The Embedded Booloader executable image for a specific PCB must exist on the PCB in advance. If not, it must be downloaded to the PCB with a BDM debugger like the P&E Multilink BDM debugger for HCS08. See Section 1.1.1 Ported Targets for more details.
NOTE
Use caution when making an 802.15.4/Zigbee Application with the Embedded Bootloader. Several versions (different version numbers) exist with different supported features. Ensure that you do not use a feature that is not supported by the Embedded Bootloader version on the PCB and that a version of the Embedded Bootloader is preloaded on the PCB.
5.1.2 Application Support Files
A few application source files must be included in the 802.15.4/Zigbee application for proper interface to the Embedded Bootloader. See Section 5.3, Application Support Files for more details.
Freescale Semiconductor | Embedded Bootloader Reference Manual, Rev. 0.0 |