16 CHAPTER 2
WINDOWS 3.X AND DOS
1.Make sure that a Card Services software is installed on your com- puter. This section uses CardSoft as an example, so the com- mands you enter may differ from those used here. Refer to your vendor’s documentation for the correct commands, if needed.
2.Enter the following command at the prompt:
C:\CARDINFO
If the Netopia ISDN PC Card is detected, the following message is returned:
Slot 0:
Card Type = Modem (COM2)
Manufacturer = Farallon Communications, Inc. Product Name = Netopia ISDN PC Card
Slot 1:
Slot 1 is empty
3.Enter the following command at the prompt:
C:\TELIX
4.Press Alt+P to open the Port Configuration screen. Configure the COM port that was returned when the Netopia ISDN PC Card was detected. Set the Speed to 115200, then press Enter to save your changes and exit the screen.
5.Go to Chapter 4, “VT100 Configuration Tool,” and continue from there.