Encore electronic UM014605-0208, Z8ENCORE000ZCO user manual Inserting a New Plug Configuration

Page 11

Z8 Encore!® Flash Microcontroller Development Kit

User Manual

7

The 9 V DC universal power supply features three different plug configu- rations, the power supply and a tool that aids in removing one plug con- figuration to insert another.

Follow the steps below to substitute one plug configuration for another:

1.Using the removal tool, place the power supply in the round hole at the top of the current plug configuration.

2.Press down to disengage the keeper tab and push the plug configura- tion out of its slot.

3.Select the plug configuration of choice for your location, and insert it into the slot left by the previous plug configuration.

4.Push the new plug configuration down until it snaps into place (see Figure 4).

Figure 4. Inserting a New Plug Configuration

UM014605-0208

Installation

Image 11
Contents Z8 Encore! Flash Microcontroller Development Kit Revision Date Level Description Revision HistoryZ8 Encore! Flash Microcontroller Development Kit Table of Contents Schematics Index Customer Support Introduction Kit ContentsSoftware on CD-ROM Z8 Encore! Development Kit ContentsDocumentation Device driver software is installed with ZDS II and residesSystem/Software Requirements Supported Host System ConfigurationSetting up the Evaluation Board InstallationEvaluation Board External Connections Inserting a New Plug Configuration Installing the ZDS II-Z8 Encore! Software Getting Started Using ZDSZ8 Encore! Evaluation Board Introduction FeaturesMajor Z8 Encore! Evaluation Board Blocks Block DiagramZ8 Encore! Evaluation Board Block Diagram MCU Function/Port G Bit No LED ArrayLED Anode Assignments Function/Port E Bit No Serial Communications DevicesI2C Interface LED AddressingDevice/Bit No Value IrDA TransceiverSPI Interface Expansion Module Interface Power and Communication InterfacesSmart Cable Z8 Encore! Flash Microcontroller Development Kit Header J6 Pin No Signal Name Function Direction CommentsPE7 Header J8 Z8 Encore! Flash Microcontroller Development Kit Header J8 Reset Header Function Registers or Devices Configuration Headers/JumpersConfiguration Headers and Jumpers Related HeadersShunt Status Function Device Affected J6.9-J6.11-Modem Enable/DisableJ6.12-J6.14-Console Enable/Disable Function Device or Register Affected J10 IrDA Enable/DisableJ9 Vref Shunt Status Function Device or Register AffectedShunt Position Function Device Affected J12-RS-4851Enable First InterfaceJ13-RS-4851Enable Second Interface Second RS-485 interface termination None Resistors disabled Embedded Modem Embedded Modem PlacementPushbuttons Sales Order Number Part Number ConfigurationZ8 Encore! Flash Microcontroller Development Kit SchematicsPE0 Modem Schematic, Z8F Encore Evaluation Board Z8 Encore! Smart Cable Index I2C Z8 Encore! Flash Microcontroller Development Kit Customer Support Document Disclaimer As used herein