Encore electronic UM014605-0208, Z8ENCORE000ZCO user manual Getting Started, Using ZDS

Page 13

Z8 Encore!® Flash Microcontroller Development Kit

User Manual

9

Getting Started

Using ZDS II

Follow the steps below to open an existing project:

1.Connect the Evaluation board to the host PC’s serial communications port using the Smart Cable.

2.Apply 9 V DC power to the Evaluation board.

3.Run the ZDS II Software (Start > Programs > ZDS II-Z8

Encore! F640x_<Version>ZDS II-28 Encore! F640x_<Version>).

4.Select Open Project from the File menu. The Open Project dialog box appears.

5.Select samples. The samples folder appears.

6.Select the Z8F640x_ledBlink folder and then the src folder to access the ledBlink.pro project file.

7.Select the ledblink.pro file. The initial ZDS II program screen opens.

8.Click Rebuild All and then the Reset icon to

connect and download the code to the Evaluation board.

9.Click Go icon to start the program.

For more information, refer to Zilog Developer Studio II—Z8 Encore® User Manual (UM0130), supplied with the documentation on the CD- ROM or available for download at www.zilog.com.

UM014605-0208

Installation

Image 13
Contents Z8 Encore! Flash Microcontroller Development Kit Z8 Encore! Flash Microcontroller Development Kit Revision HistoryRevision Date Level Description Table of Contents Schematics Index Customer Support Introduction Kit ContentsSoftware on CD-ROM Z8 Encore! Development Kit ContentsDocumentation Device driver software is installed with ZDS II and residesSystem/Software Requirements Supported Host System ConfigurationSetting up the Evaluation Board InstallationEvaluation Board External Connections Inserting a New Plug Configuration Installing the ZDS II-Z8 Encore! Software Getting Started Using ZDSZ8 Encore! Evaluation Board Introduction FeaturesMajor Z8 Encore! Evaluation Board Blocks Block DiagramZ8 Encore! Evaluation Board Block Diagram MCU LED Anode Assignments LED ArrayFunction/Port G Bit No I2C Interface Serial Communications DevicesLED Addressing Function/Port E Bit NoSPI Interface IrDA TransceiverDevice/Bit No Value Smart Cable Power and Communication InterfacesExpansion Module Interface Z8 Encore! Flash Microcontroller Development Kit Header J6 Pin No Signal Name Function Direction CommentsPE7 Header J8 Z8 Encore! Flash Microcontroller Development Kit Header J8 Reset Configuration Headers and Jumpers Configuration Headers/JumpersRelated Headers Header Function Registers or DevicesJ6.12-J6.14-Console Enable/Disable J6.9-J6.11-Modem Enable/DisableShunt Status Function Device Affected J9 Vref J10 IrDA Enable/DisableShunt Status Function Device or Register Affected Function Device or Register AffectedJ13-RS-4851Enable Second Interface J12-RS-4851Enable First InterfaceShunt Position Function Device Affected Second RS-485 interface termination None Resistors disabled Embedded Modem Embedded Modem PlacementPushbuttons Sales Order Number Part Number ConfigurationZ8 Encore! Flash Microcontroller Development Kit SchematicsPE0 Modem Schematic, Z8F Encore Evaluation Board Z8 Encore! Smart Cable Index I2C Z8 Encore! Flash Microcontroller Development Kit Customer Support Document Disclaimer As used herein