Encore electronic UM014605-0208, Z8ENCORE000ZCO user manual J9 Vref, J10 IrDA Enable/Disable

Page 29

Z8 Encore!® Flash Microcontroller Development Kit

User Manual

Table 10. J7 External Vref

25

Shunt Status Function

Device or Register Affected

IN

External Vref is used for ADC

Internal Vref is disabled.

OUT

Internal Vref is used for ADC

Internal Vref is enabled.

Table 11. J9 Vref

 

Function

Device or Register Affected

J9-1

Test point to external Vref

Vref

 

 

 

J9-2

GND

None

 

 

 

Table 12. J10 IrDA Enable/Disable

Shunt Status

Function

Device Affected

IN

IrDA enabled

Only the IrDA interface is operational.

 

 

 

OUT

IrDA disabled

UART0 communicates through RS-232.

 

 

If J6 12-14 is IN Port A (3-5) can be

 

 

assigned to other functions (console

 

 

connector P1 is disabled).

 

 

If J6 12-14 is OUT console connector P1

 

 

is enabled (Port A (3-5) is assigned to

 

 

UART0).

 

 

 

Note: If the IrDA board is installed the Console port is disabled.

UM014605-0208

Z8 Encore!® Evaluation Board

Image 29
Contents Z8 Encore! Flash Microcontroller Development Kit Revision Date Level Description Revision HistoryZ8 Encore! Flash Microcontroller Development Kit Table of Contents Schematics Index Customer Support Introduction Kit ContentsSoftware on CD-ROM Z8 Encore! Development Kit ContentsDocumentation Device driver software is installed with ZDS II and residesSystem/Software Requirements Supported Host System ConfigurationSetting up the Evaluation Board InstallationEvaluation Board External Connections Inserting a New Plug Configuration Installing the ZDS II-Z8 Encore! Software Getting Started Using ZDSZ8 Encore! Evaluation Board Introduction FeaturesMajor Z8 Encore! Evaluation Board Blocks Block DiagramZ8 Encore! Evaluation Board Block Diagram MCU Function/Port G Bit No LED ArrayLED Anode Assignments I2C Interface Serial Communications DevicesLED Addressing Function/Port E Bit NoDevice/Bit No Value IrDA TransceiverSPI Interface Expansion Module Interface Power and Communication InterfacesSmart Cable Z8 Encore! Flash Microcontroller Development Kit Header J6 Pin No Signal Name Function Direction CommentsPE7 Header J8 Z8 Encore! Flash Microcontroller Development Kit Header J8 Reset Configuration Headers and Jumpers Configuration Headers/JumpersRelated Headers Header Function Registers or DevicesShunt Status Function Device Affected J6.9-J6.11-Modem Enable/DisableJ6.12-J6.14-Console Enable/Disable J9 Vref J10 IrDA Enable/DisableShunt Status Function Device or Register Affected Function Device or Register AffectedShunt Position Function Device Affected J12-RS-4851Enable First InterfaceJ13-RS-4851Enable Second Interface Second RS-485 interface termination None Resistors disabled Embedded Modem Embedded Modem PlacementPushbuttons Sales Order Number Part Number ConfigurationZ8 Encore! Flash Microcontroller Development Kit SchematicsPE0 Modem Schematic, Z8F Encore Evaluation Board Z8 Encore! Smart Cable Index I2C Z8 Encore! Flash Microcontroller Development Kit Customer Support Document Disclaimer As used herein