Encore electronic Z8ENCORE000ZCO, UM014605-0208 Installing the ZDS II-Z8 Encore! Software

Page 12

Z8 Encore!® Flash Microcontroller Development Kit

User Manual

8

Installing the ZDS II—Z8 Encore!® Software

Follow the steps below to install the software tools:

1.Load the ZDS II—Z8 Encore! Flash MCU CD into the CD-ROM drive of the host PC. The CD launches DemoShield automatically and provides a menu to install the product and documentation. Select INSTALL PRODUCTS followed by INSTALL ZDS II to display the Installation Wizard.

Note: Software versions used in the following illustrations are for reference only. You may have an updated version.

2.Click Next to continue with the installation. The License Agreement appears.

3.Select Yes to accept the agreement and proceed with the installation.

4.After selecting Yes, the Choose Destination Location screen appears. Follow the directions on the screen and choose whether to install ZDS II in the default location or in some other folder. Click Next.

5.The Select Program Folder screen appears. Follow the on-screen instructions and click Next.

6.After selecting Next, the Installation Wizard completes the installation.

7.When the installation is complete, another screen appears asking you to register the product online at www.zilog.com. To register at a later time the registration link to the internet site is provided in the ZDS II Help menu.

8.The following directory is installed on the host PC, assuming all installation settings remain at their defaults:

C:/Program Files/ZiLOG/ZDSII_Z8Encore!_F640X_<Ver-

sion>.

UM014605-0208

Installation

Image 12
Contents Z8 Encore! Flash Microcontroller Development Kit Revision History Z8 Encore! Flash Microcontroller Development KitRevision Date Level Description Table of Contents Schematics Index Customer Support Kit Contents IntroductionZ8 Encore! Development Kit Contents Software on CD-ROMDevice driver software is installed with ZDS II and resides DocumentationSupported Host System Configuration System/Software RequirementsInstallation Setting up the Evaluation BoardEvaluation Board External Connections Inserting a New Plug Configuration Installing the ZDS II-Z8 Encore! Software Using ZDS Getting StartedIntroduction Features Z8 Encore! Evaluation BoardBlock Diagram Major Z8 Encore! Evaluation Board BlocksZ8 Encore! Evaluation Board Block Diagram MCU LED Array LED Anode AssignmentsFunction/Port G Bit No Serial Communications Devices I2C InterfaceLED Addressing Function/Port E Bit NoIrDA Transceiver SPI InterfaceDevice/Bit No Value Power and Communication Interfaces Smart CableExpansion Module Interface Pin No Signal Name Function Direction Comments Z8 Encore! Flash Microcontroller Development Kit Header J6PE7 Header J8 Z8 Encore! Flash Microcontroller Development Kit Header J8 Reset Configuration Headers/Jumpers Configuration Headers and JumpersRelated Headers Header Function Registers or DevicesJ6.9-J6.11-Modem Enable/Disable J6.12-J6.14-Console Enable/DisableShunt Status Function Device Affected J10 IrDA Enable/Disable J9 VrefShunt Status Function Device or Register Affected Function Device or Register AffectedJ12-RS-4851Enable First Interface J13-RS-4851Enable Second InterfaceShunt Position Function Device Affected Second RS-485 interface termination None Resistors disabled Embedded Modem Placement Embedded ModemSales Order Number Part Number Configuration PushbuttonsSchematics Z8 Encore! Flash Microcontroller Development KitPE0 Modem Schematic, Z8F Encore Evaluation Board Z8 Encore! Smart Cable Index I2C Z8 Encore! Flash Microcontroller Development Kit Customer Support As used herein Document Disclaimer