Enterasys Networks RBT-4102 manual Operation Using 5 GHz Channels in the European Community

Page 7

Operation Using 5 GHz Channels in the European Community

The user/installer must use the provided configuration utility to check the current channel of operation and make necessary configuration changes to ensure operation occurs in conformance with European National spectrum usage laws as described below and elsewhere in this document.

Allowed 5GHz Channels in Each European Community Country

Allowed Frequency Bands

Allowed Channel Numbers

Countries

5.15 - 5.35* & 5.470 - 5.725 GHz

36, 40, 44, 48, 52, 56, 60, 64,

Austria, Belgium,

 

100, 104, 108, 112, 116, 120,

Cyprus, Czech

 

124, 128, 132, 136, 140

Republic, Denmark,

 

 

Estonia, Finland,

 

 

France, Germany,

 

 

Iceland, Ireland, Italy,

 

 

Latvia, Liechtenstein,

 

 

Lithuania, Luxembourg,

 

 

Malta, Netherlands,

 

 

Norway, Poland,

 

 

Portugal, Slovakia,

 

 

Slovenia, Spain,

 

 

Sweden, Switzerland,

 

 

U.K.

 

 

 

5 GHz Operation Not Allowed

None

Greece, Hungary

 

 

 

* Outdoor operation is not allowed using 5.15-5.35 GHz bands (Channels 36 - 64).

Countries of Operation & Conditions of Use in the Asia, Pacific, and Middle East Communities

This device is intended to be operated in all countries listed below of the Asia, Pacific, and Middle East Community. Requirements for indoor vs. outdoor operation, license requirements and allowed channels of operation apply in some countries as described below:

Note: The user must use the configuration utility provided with this product to ensure the channels of operation are in conformance with the spectrum usage rules for countries as described below.

This device requires that the user or installer properly enter the current country of operation in the command line interface as described in the user guide, before operating this device.

This device will automatically limit the allowable channels determined by the current country of operation. Incorrectly entering the country of operation may result in illegal operation and may cause harmful interference to other system.

The user is obligated to ensure the device is operating according to the channel limitations, indoor/outdoor restrictions and license requirements for each country as described in this document.

This device employs a radar detection feature required for operation in the 5 GHz band. This feature is automatically enabled when the country of operation is correctly configured for any of the countries listed below. The presence of nearby radar operation may result in temporary interruption of operation of this device. The radar detection feature will automatically restart operation on a channel free of radar.

v

Image 7
Contents Enterasys RoamAbout Page Page RBT-4102, RBT-4102-BG, and RBT-4102-EU CompliancesIii RBT-4102-EUIndustry Canada Statement EC Conformance Declaration Operation Using 5 GHz Channels in the European Community Usage Vii RBT-4102C and RBT-4102C-EUViii RBT-4102C-EUPage Operation Using 5 GHz Channels in the European Community EC-Konformitätserklärung English XiiItalian IT XiiiXiv Power Cord SetPower Cord Set Xvi Hazardous SubstancesYou and Enterasys agree as follows XviiXviii Xix Compliances Xxi Xxii Table of Contents Xxiv Appendix C SpecificationsAssociated Documents PrefacePurpose Intended AudienceXxvi Getting HelpWorld Wide Web Phone Introduction Hardware Description Package ChecklistTop Panel Rear Panel Hardware DescriptionAntennas External Antenna ConnectorsLED Indicators Component DescriptionConsole Port Security SlotStatus Description Ethernet Port Power Connector Reset ButtonIntroduction Hardware Installation Hardware Installation Page Hardware Installation Using the CLI Access Point ConfigurationRequired Connections Logging Access Point ConfigurationUsing the CLI Enter no ip dhcp to disable Dhcp Using the CLI Using Web Management Using Web Management Access Point Configuration Using Web Management Access Point Configuration Using Web Management Access Point Configuration Using Web Management Access Point Configuration Network Configuration Network Topologies Ad Hoc Wireless LAN no Access PointInfrastructure Wireless LAN Infrastructure Wireless LAN for Roaming Wireless PCs Infrastructure Wireless Bridge Network Configuration Symptom Action Appendix a TroubleshootingDiagnosing Access Point Indicators Troubleshooting ChartTroubleshooting Twisted-Pair Cable Assignments Appendix B Cables and Pinouts10/100BASE-TX Pin Assignments Pin MDI Signal Name MDI-X Signal NameCrossover Wiring Straight-Through WiringConsole Port Pin Assignments Wiring Map for Serial CableData Rate Appendix C SpecificationsGeneral Specifications Maximum ChannelsModulation Type Network ConfigurationAC Power Adapter Unit Power SupplyPhysical Size WeightLED Indicators TemperatureStandards Radio Signal CertificationSafety CompliancesIeee 802.11g Data Rate SensitivityIeee 802.11b Data Rate Ieee 802.11a Transmit PowerData Rate 15-5.250 25-5.350 50-5.700 725-5.825 Operating Range 802.11a Wireless Distance Table Speed and Distance Ranges1802.11g Wireless Distance Table Speed and Distance Ranges1 802.11b Wireless Distance Table Speed and Distance Ranges1External Antennas External Antennas Specifications Index-1 IndexIndex-2
Related manuals
Manual 168 pages 49.88 Kb