Enterasys Networks RBT-4102 manual Enter no ip dhcp to disable Dhcp

Access Point Configuration

c.Enter no ip dhcp to disable DHCP.

RoamAbout 4102(if-ethernet)#no ip dhcp

DHCP client state has changed. Please reset AP for change to take effect.

RoamAbout 4102(if-ethernet)#exit

RoamAbout 4102#reset board

Reboot system now? <y/n>: y

Username: admin

Password:********

RoamAbout 4102#configure

Enter configuration commands, one per line. End with CTRL/Z RoamAbout 4102(config)#interface ethernet

Enter Ethernet configuration commands, one per line.

RoamAbout 4102(if-ethernet)#

d.Set the IP Address. Enter ip address ip-address netmask gateway, where ip-addressis the access point’s IP address, netmask is the network mask for the network, and gateway is the default gateway router. Check with your system administrator to obtain an IP address that is compatible with your network.

RoamAbout 4102(if-ethernet)#ip address ip-address netmask gateway

RoamAbout 4102(if-ethernet)#end RoamAbout 4102(config)#

After configuring the access point’s IP parameters, you can access the management interface from anywhere within the attached network. The command line interface can also be accessed using Telnet from any computer attached to the network.

e. Go to Step 4.

4.Change the default username and password. Enter username and specify a unique user name; enter password and specify a unique password.

RoamAbout 4102(config)#username JohnBL

RoamAbout 4102(config)#password ******

Confirm new password: ******

RoamAbout 4102(config)#

3-4