Ecom Instruments ECOM-EF24F2G user manual 5Management Software Guide, Important Information

Page 24

5 Management Software Guide

5Management Software Guide

Introduction

The ECOM Windows remote management software allows user to configure the management function though the LAN port. It uses a specialized RRCP protocol and does not use the IP protocol. It operates inside the Ethernet network.

Important Information

WinPCap application (included in the CD) must be installed before installing the management software

Please make sure to press the “Update” button after changes Please make sure to “write to the switch” after change settings

The ECOM-ES24F2G has a factory reset button on the back panel. This button will restore switch’s setting to factory’s default values.

If your management program can’t find the switch, please press the reset button.

If the application says authentication failure and the authentication key is correct, please press “edit Switch Database” and clear all entries.

Minimum system requirements

To use Remote Management Application, it is necessary that your system include the following components:

Hardware

Pentium class processor 32 MB RAM

Software

Windows® 98 (Second Edition for non-English operating systems), WinME, WinNT

4.0with Service Pack 6, Win2000, or WinXP WinPCap 3.0 (included in the CD)

16

Ecom ES24F2G Gigabit Ethernet Switch User’s Manual V1.0

Image 24

Contents ECOM-EF24F2G About this User’s Manual Table of Contents Preparation Before Installation Iii Appendix a Product Specifications Appendix B Troubleshooting Figures Tables Management Features Product OverviewIntroduction Windows Remote Management softwareWhat is VLAN? In-Band and Out-of-Band ManagementDefining Vlan What is Priority Queuing? Table Maintenance via SignalingPort-based Vlan 802.1q Vlan StandardProduct Features Standard Compliance Smart Remote Managements100M Dimensions 432 × 180 × 44 mm, 19 rack mountable Preparation before Installation Unpack the PackageReset Button Front PanelPower Switch AC Power ConnectorPower Switch Power Connector Rear PanelInstallation of the Switch Quick InstallationSteps to Quick Installation Power on the SwitchDesktop Installation Installation Site PreparationCabling Guide For 100BASE-TX and 1000Base-T portsAuto MDI/MDI-X function Ohm Category 3, 4, 5 UTP/STP cableConnecting to Power Making your own UTP/STP cable Power Switch Power Connector Power Outlet LED Indicators System LEDs10/100Mbps Port LEDs Gigabit Port LEDPower LED LED Table5Management Software Guide Important InformationMinimum system requirements Installing the Software Starting the SoftwareStatus Functions Overview SubmenuUpdate button Switch database buttonDiscovered device information Network topology link vectorMIB Counter Submenu Port Status Submenu Byte Count ButtonPacket Count Button Bandwidth Utilization ButtonManagement Software Guide Configuration Functions Port Configuration SubmenuGlobal Configuration Submenu Qos Configuration Submenu Vlan Configuration SubmenuRefresh button Add Vlan buttonPort Tagging Control button Setting Vlan Control Registers Vlan Control SubmenuDevice Feature Security Function Diagnostic Function Fault InformationDevice Reset Pull down Menus System menuOptions menu Appendix a Product Specifications Standard ComplianceTransmission method Appendix B Troubleshooting