5. When a CD is playing, the sound "skips." The CD is severely scratched or dirty.
The Nº390S is on an unstable surface or is too close to your speakers.
6. The linked functions don’t work.
The Link cable is disconnected, or is connected incorrectly. Check your Link connections.
The Link options are turned off.
The preamplifier is not aliased (renamed) for the Nº39.
The processor (if one is being used) does not have one of its inputs tied to the Nº390S.
Try turning off/disconnecting AC power from both the preamplifier and the Nº390S. After several seconds, restore AC power to the preamplifier, then turn on the Nº390S’s main power switch. Never operate the main power switch without first making sure that power is turned off to your receiver, integrated amplifier, or preamplifier/power amplifier.
Some associated Mark Levinson components may have older versions of the system software that do not fully support all Linked functions. Contact your Mark Levinson dealer with the model and serial numbers of your Mark Levinson components. If needed, new EPROMs will be
provided at no charge.
57
7.The Remote Control doesn’t operate the Nº390S.
The Remote Control is at the wrong angle relative to the Nº390S, and the Nº390S can’t receive the signal.
The sensor window on the front panel of the Nº390S is dirty or blocked.
The Remote Control’s projection lens is dirty.
Fluorescent lighting or sunlight is interfering with the operation of the Remote Control.
The Remote Control’s batteries are weak and need to be replaced.
The Remote Control’s batteries are installed incorrectly.