MicroBoards Technology user manual Setting up the CWR-424-52 duplicator, Copy Process

CWR-424-52

Microboards Technology LLC

Setting up the CWR-424-52 duplicator

Set up the CWR-424-52 duplicator with the following conditions:

•19” Rack mount position or

•On a level and stable surface

•In a well ventilated location

•Temperature and humidity:

oTemperature: 5-40° C

oHumidity: 20-80%RH (no dew formation)

Do not locate the CWR-424-52 duplicator:

Under direct sunlight (If the machine is exposed to sunlight, the light should be blocked by a curtain or blind.)

In a place where there is a lot of vibration Near open flame

In a place where the temperature and humidity change drastically Near a heating device such as a heater or furnace

In a location where air from an air conditioner blows directly onto the unit Near a container filled with water such as a vase

In a dusty location

oDust and dirt can decrease the productivity of the duplicator dramatically. It is very important to keep the system in a clean and dust free environment.

In winter during times of low humidity or in a location where static electricity is generated, use an anti-static-electricity mat or humidifier to prevent static electricity.

Copy Process

The advantage of the CWR-424-52 is the quick and easy operation to burn CD information. You can burn CD-R’s by pressing the button only once with the CWR-424-52 as follows;

Turn on CWR-424-52, and it begins to initialize.

oThe LED’s turn on, one at a time and then go off, leaving the 1st mode light on. o Insert a Master disc into the Master drive and blank discs into writers.

o Wait for ten seconds until the drives are ready. o Press the ‘START’ button (press it once).

o The copy process begins.

Refer to the “LED’s Status” and “Copy Mode Process” sections for details.

Using Audio Masters:

When copying Audio masters with a large number of tracks, the system can take 3 to 5 minutes to

4