Denon AVR-1082 manual Remote Control Unit, After completing system setup, Inserting the batteries

ENGLISH

After completing system setup

This button can be pressed at any time during the system setup process to complete the process.

1	SETUP	At the System Setup Menu, press the SYSTEM SETUP button.
		The changed settings are entered and the on-screen display turns off.

8REMOTE CONTROL UNIT

•The included remote control unit (RC-884) can be used to operate not only the AVR-3802 but other remote control compatible DENON components as well. In addition, the memory contains the control signals for other remote control units, so it can be used to operate non-Denon remote control compatible products.

•On-screen display signals

		Signals input to the AVR-3802		On-screen display signal output
	VIDEO signal input		S-video signal	VIDEO MONITOR OUT video	S-video MONITOR OUT video
		jack (yellow)	input jack	signal output jack (yellow)	signal output jack
1		E	E	C	C
2		C	E	C	E
3		E	C	E	C
4		C	C	E	C
(C: Signal		E: No signal)		(C: On-screen signals output E: On-screen signals not output)

NOTES:

•The on-screen display signals are not output from the color difference (component) video signal MONITOR OUT jacks.

•For 4 above, the on-screen display signals are output to the VIDEO MONITOR OUT video signal output jack (yellow) if the monitor TV is not connected to the S-video MONITOR OUT video signal output jack.

Inserting the batteries

qRemove the remote control unit’s rear cover.

wSet three R6P/AA batteries in the battery compartment in the indicated direction.

ePut the rear cover back on.

Notes on Batteries

•Use R6P/AA batteries in the remote control unit.

•The batteries should be replaced with new ones approximately once a year, though this depends on the frequency of usage.

•Even if less than a year has passed, replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the set. (The included battery is only for verifying operation. Replace it with a new battery as soon as possible.)

•When inserting the batteries, be sure to do so in the proper direction, following the “≈” and “√” marks in the battery compartment.

•To prevent damage or leakage of battery fluid:

•Do not use a new battery together with an old one.

•Do not use two different types of batteries.

•Do not short-circuit, disassemble, heat or dispose of batteries in flames.

•Remove the batteries from the remote control unit when you do not plan to use it for an extended period of time.

•If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries.

•When replacing the batteries, have the new batteries ready and insert them as quickly as possible.

Using the remote control unit

30° 30°

Approx. 7 m

•Point the remote control unit at the remote sensor on the main unit as shown on the diagram.

•The remote control unit can be used from a straight distance of approximately 7 meters from the main unit, but this distance will be shorter if there are obstacles in the way or if the remote control unit is not pointed directly at the remote sensor.

•The remote control unit can be operated at a horizontal angle of up to 30 degrees with respect to the remote sensor.

NOTES:

•It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light.

•Do not press buttons on the main unit and remote control unit simultaneously. Doing so may result in malfunction.

•Neon signs or other devices emitting pulse-type noise nearby may result in malfunction, so keep the set as far away from such devices as possible.

16