Denon AVR-1082 manual Setting the channel level

4	Once “Meter” or “Feet” is selected in Step 3,
	the Delay Time screen appears automatically.

5	TUNING	Select the speaker to be set.
	BAND	MODE
	TUNING

ENGLISH

Setting the channel level

•Use this setting to adjust so that the playback level between the different channels is equal.

•From the listening position, listen to the test tones produced from the speakers to adjust the level.

•The level can also be adjusted directly from the remote control unit. (For details, see page 27.)

•When using both surround speakers A and B, their playback levels can be adjusted separately.

1	TUNING	At the System Setup Menu select “Channel Level”.
	BAND	MODE
	TUNING

6	TUNING
BAND	MODE
	TUNING

Set the distance between the center speaker and listening position.

The distance changes in units of 0.1 meters (1 foot) each time the button is pressed. Select the value closest to the measured distance.

Example: When the distance is set to 3.6 m for the center speaker

2	ENTER	Switch to the Channel Level screen.
	SHIFT

If “Yes” is selected for “Default”, the settings are automatically reset to the default values.

Please note that the difference of distance for every speaker should be 4.5 m (15 ft) or less. If you set an invalid distance, a CAUTION notice, such as screen right will appear. In this

3	TUNING	Select “Test Tone Mode”.
	BAND	MODE
	TUNING

case, please relocate the blinking speaker(s) so that its distance is no larger than the value shown in highlighted line.

7	ENTER	Enter the setting.
	SHIFT	The System Setup Menu reappears.

The AVR-3802 automatically sets the optimum surround delay time for the listening room.

NOTES:

4	TUNING
BAND	MODE
	TUNING

Select the mode.

Select “Auto” or “Manual”.

• Auto:

Adjust the level while listening to the test tones produced automatically from the different speakers.

• Manual:

Select the speaker from which you want to produce the test tone to adjust the level.

Example: When the “Auto” mode is selected

•If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 9).

5	TUNING
		TUNING
BAND	MODE
	BAND	MODE
	TUNING
		TUNING

Select “Surr. Sp.”, then select the surround speaker(s) from which you want to produce the test tone (A, B or A+B).

•Surr. Sp.: A

Adjusts the balance of the playback level between the channels when using surround speaker A.

•Surr. Sp.: B

Adjusts the balance of the playback level between the channels when using surround speaker B.

•Surr. Sp.: A+B

Adjusts the balance of the playback level between the channels when using surround speakers A and B at the same time.

The “Surr. Sp.” can only be selected when both surround speakers A and B have been selected at the “Speaker Configuration” (when both A and B have been set to “Large” or “Small”).

6	TUNING	Select “Test Tone Start”.
	BAND	MODE
	TUNING

13