Dell TL2000 manual Configure Library Drives, Menu Item Description 2U Library 4U Library

vInternal Label - Encrypt All: Check your tape backup software application documentation to see if this feature is supported.

10.A primary and secondary EKM server can be set for each logical library. Each partition has its own Encryption and EKM settings. Maintaining primary and secondary EKM servers is desired for maximum availability of encrypted backup and recovery. These settings are required for Library Managed Encryption only. Enter the EKM Server Setting information.

vPrimary IP address (IPv4 or IPv6): Enter the IP address of the primary EKM server.

vPrimary TCP port: After entering the Primary IP address, the library will automatically set the value of the Primary TCP port.

vSecondary IP address (IPv4 or IPv6): Enter the IP address of the secondary EKM server.

vSecondary TCP port: After entering the Secondary IP address, the library will automatically set the value of the Secondary TCP port.

Note: The Default Port for TCP (SSL disabled) is 3801. The Default Port for SSL is 443. These values are the default values set by the library. They can be changed depending on the user configuration but the user has to make sure they match the EKM properties file.

Note: If SSL is enabled the encryption host configuration will request a SSL port instead of a TCP port. Review the Dell PowerVault Encryption Key Manager User’s Guide for instructions to locate the appropriate port settings.

11.Click Activate to apply the changes.

12.Install the Dell Encryption Key Manager (EKM) application on your host. Refer to the Dell EKM documentation provided with your Encryption packet. The EKM IP address and EKM port will be provided to the user by the EKM application.

Configure Library: Drives

This page allows you to modify the current ID assigned to a SCSI or Fibre Channel drive. This page allows any drive in the library to be powered off by de-selecting the check mark in the Power On box. The displayed information will vary depending on the library model and drive type (SCSI, SAS, or Fibre Channel). Table 5-11lists all available elements on this page. An ″X″ indicates that the element displays for the specified drive type.

Table 5-11. Drive Identity page elements

Menu Item	Description		2U Library				4U Library
		SCSI		Fibre	SAS	SCSI		Fibre	SAS
SCSI ID	For each SCSI drive, click on the drop down list	X				X
	and select the number of the slot in which the
	drive is located.
Power On	For each drive, click in the box to power ON the	X		X	X	X		X	X
	selected drive.
Control Path	The control path drive communicates messages	X		X	X	X		X	X
	from the host to the library. Select this option for
	each drive that you want to be a control path
	drive. At least one drive in each logical library
	must be designated as a control path drive.

Port A Configuration:

Chapter 5. Operations 5-43